HomeNewsIndustry news

SK Upright vs. SHF Flanged Shaft Supports: Stopping Rod Slip on Automated Frames

Date: 2026.11.16   Views: 8

Shaft Support
1. Upright Base vs. Face-Mount Geometry

SK series supports sit upright on a flat base plate with two vertical mounting holes. They work best when your linear shaft runs parallel to a machine bed or t-slot profile, holding the rod centerline at a fixed height above the deck.

SHF series brackets bolt flat against a vertical bulkhead or side plate. Because the shaft passes straight through the wall, SHF supports save space on compact Z-axis drops or push-pull pneumatic actuator plates.

Both styles rely on a single split-clamp screw to squeeze the aluminum bore around the chrome rod. Unlike set-screw collars that dig burrs into hardened steel, split clamps wrap evenly around the shaft diameter without marring the chrome skin.

2. Shop-Floor Mounting and Alignment Habits
  • Drop Base Bolts Loose First: Set both SK blocks onto your machine bed and thread the mounting screws hand-tight. Slide the chrome shaft through both bores and run a linear bearing back and forth a few times so the blocks find their natural centerline before you torque the base bolts.

  • Watch the Clamp Gap: Tighten the split-clamp bolt gradually with a hex key. Stop once the shaft stops spinning by hand—cranking the bolt until the aluminum slit closes completely can snap the clamp ear off.

  • Check Center Height Tolerance: Aluminum extrusion brackets can vary by a few hundredths of a millimeter from batch to batch. Sweep the shaft top with a dial indicator after bolting down both ends; slip thin brass shim stock under the low bracket if the rod slopes.

3. Common Field Questions

Q: Why does my chrome shaft still slide axially inside the SK block after tightening the clamp screw?

A: Either shipping oil is still coating the shaft ends, or you paired an undersized h7 shaft with a worn clamp bore. Wipe both the shaft end and the inside of the aluminum bore with alcohol so the metal surfaces bite dry.

Q: Can SK shaft supports carry heavy radial loads in the middle of a long span?

A: No. SK and SHF blocks are meant strictly for holding shaft ends. If your span runs past 800 mm and carries heavy tooling, switch to an SBR fully supported rail so the shaft rests on an aluminum base from end to end.

Leave base bolts loose while self-centering the rod, clean off shipping oil for dry clamp grip, and never over-crush the split ear—that prevents most shaft support headaches on custom rigs.

We value your privacy

We use cookies to enhance your browsing experience, serve personalized ads or content, and analyze our traffic. By clicking "Accept All", you consent to our use of cookies.

Consent Preferences

Consent Preferences